How To Draw Portraits With Prismacolor Pencils

Download Article

Download Article

Blending Prismacolor pencils tin can be difficult even for experienced artists. Unlike other mediums like charcoal, chalk, or graphite, colored pencils cannot be blended with pieces of scrap newspaper or a tortillion. However, in that location are techniques you tin can employ and solvents available and so you can accomplish the blended consequence you desire with your pencils.

1. 1

   Layer your colors to create a blending upshot. By layering one color on top of some other, you tin can lighten or darken it to accomplish the hue you have in listen. This should be done lightly and with every bit few strokes as possible. Yous can always add together more than of your layer color, just one time added, it'll be hard, if not impossible, to remove.

   • You can lighten dark colors with a layer of a lighter colour, similar white, over elevation. This can too assistance with softening colors, like the ane found in pare tones.^[one]

2. two

   Utilize a blender pencil. This tool looks like a articulate colored pencil and it is intended specifically for blending colored pencils.^[2] Information technology is sometimes referred to every bit a colorless blender. Rub this tool firmly upon the colors you are trying to blend and laissez passer it back and forth until the desired level of blending is reached.^[iii]

   • By spreading a thick layer-color over a base of operations-color with your blender pencil, you lot can create a glaze effect over peak the base. This will also impart a blended effect to your artwork.
   • Make sure to use a pencil that is not sharp and then that the lines are softer.^[iv]

   Advertisement

3. 3

   Spread colored pencil with a bristle brush. With a moderately strong bristle castor, you can drag colors yous've already applied to the page around it. Thin coverage will give your colors a lighter tone; thick concentration will intensify the color. Colors spread together will alloy.

   • You may have to experiment with this and get some feel before you become fully comfortable with the technique.
   • You should choose your brush with regard to the paper y'all have used. Thicker paper may permit y'all to use stiffer brushes for easier blending. Thinner paper might require a soft bristle brush and gentle blending over time.
   • You should also exist able to apply a tortillion to push colors around the page to create either increased or decreased brightness.^[v]

4. iv

   Smudge colors to imitate blending. Though paper and tortillions won't be effective for blending, a cloth tin can exist used to smudge colors together to attain this look. You may want to first by smudging a small, camouflaged area with a tiny piece of cloth to see how the colors blend before attempting to alloy the primary parts of your art.

   • Some cloth might blend differently than others or create a unique outcome in your drawing. Testing your cloth beforehand can prevent unintended effects when blending.^[6]

   Advertisement

1. 1

   Add your colored pencil to the paradigm. You're going to be breaking downward the lead of your Prismacolors to alloy the colors together, so you'll first demand all your colour on the folio. Get-go with your base of operations and add strokes of other color. These accent colors volition blend with the base of operations once the solvent is added.^[vii]

   • Sometimes afterward drawing with Prismacolors you might detect a waxy buildup on the colored areas. If this makes your blending more difficult, you tin can wipe away the waxy picture show with a soft, dry cloth.

2. 2

   Cull your solvent for blending. In virtually cases, mineral spirits should exist sufficient for your blending efforts, though at that place are specific brands intended for this purpose, like Gamblin Gamsol Odorless and Weber Terpinoid natural. Pour a small corporeality of this solvent in a small, resealable glass container.^[8]

   • These kind of solvents tin can intermission downwards certain mutual plastics over time. Due to this result, you should avoid using a plastic container for your solvent.
   • Yous won't demand much solvent for blending. A picayune bit goes a long manner, so a minor container will likely serve your purposes all-time.
   • A resealable container is particularly helpful when yous are drawing often with Prismacolors. This way you lot tin can reuse your solvent hands.

3. 3

   Brush on your solvent to blend the Prismacolors. Using too much solvent can cause your colors to go runny. It may take some time and practice earlier you get the knack for calculation the right amount of solvent. Generally, you should:

   • Dip an inexpensive synthetic brush into your solvent. Remove the castor, then blot excess solvent from information technology with a paper towel.
   • Brush your solvent lightly onto the expanse you are blending with your brush. Continue blending, little past footling, until yous reach the desired effect.^[9]

4. 4

   Allow your blended Prismacolors time to dry. Somewhen, the solvent will evaporate and your composite Prismacolor pb will return to its original consistency. Keep your artwork level to prevent colors from accidentally running.

   • Depending on how much solvent you needed to utilize while blending, your solvent composite art may be dry in less than an hour. In some cases, this may take upwardly to a day to completely dry out.

   Advertisement

1. 1

   Encompass unused areas on the page. Over the course of your blending, it's easy to accidentally spread color to an area you hadn't intended. To forbid this, y'all might cover the areas you don't want blending with removable tape.^[10]

   • For large areas, to save on tape yous might decide to use a piece of flake newspaper held in place by a few small pieces of tape.

2. 2

   Apply a pencil extender to become your money'due south worth. Prismacolor pencils tin can exist very expensive, so it's a practiced thought to get the most out of every pencil you purchase. A pencil extender will let you to hold the end nub of a used pencil more easily so you tin can use every concluding bit.^[11]

3. 3

   Remove wax buildup. Wax is a component used in manufacturing your colored pencils. Over time information technology can rise to the surface of your cartoon to create buildup on the image. This can exist removed without harming your artwork past wiping it away firmly with a make clean, dry textile or moderately potent bristle castor.

   • You'll oftentimes find that wax buildup occurs in areas you have heavily applied your colored pencil to a specific surface area. Go along an eye on these areas for buildup.^[12]

4. 4

   Remove marks fabricated with your Prismacolors. Prismacolor pencils get out backside marks that can be hard to erase, though you may have some success with a normal eraser. However, it's probable yous'll have the best success with an electrical eraser. Y'all can also elevator unwanted marks by applying and peeling complimentary agglutinative putty, similar the kind used to hang posters and artwork.^[13]

   • Even with an electric eraser, information technology'due south likely some remnant of the Prismacolor will remain. Avoid erasing also much to endeavour and completely erase the mark. Doing so could event in a ripped page.^[14]

5. five

   Treat your Prismacolor pencils gently. The colored cores of your Prismacolors are relatively fragile and tin pause from dropping or rough treatment. These breaks can effect in inconsistent drawing or wasted lead, then yous may want to keep your pencils in a box or example to go on them protected.^[15]

   Advertizement

Add New Question

• Question

  Can I alloy Sanford Prismacolor pencils with Primere Prismacolor pencils?

  

  Blending 2 different make colored pencils should piece of work, but as the components of these may be different, the brands may blend inconsistently.

• Question

  What is the difference between Sandford Prismacolored pencils and Prismacolor Premier?

  

  Sanford is an older brand of Prismacolor that was made in the US, and not in United mexican states. Some people take said the new Premiers are of a lower quality, the lead oftentimes is non centered, and the wood is inferior to the older brands of Prismacolor (such as the Hawkeye, Sanford, and Berol).

• Question

  What's the best way to alloy a large area (e.g. the background of a large slice of paper)?

  

  ignore me

  Community Answer

  A rag normally works forth with some solvent. If y'all utilize a colorless blender, it'll exist much more difficult and time-consuming though.

• Question

  What'south a proficient place to purchase Prismacolor pencils?

  

  You lot can buy them at your local craft store. Search for a location near y'all. Or you can buy them online.

• Question

  What is a colorless blender?

  

  A colorless blender is a tool in pencil or marking course that, when used on an area of color, blends and brightens the tones of the colored pencil. Information technology appears as a transparent liquid in markers or as a colorless form in a pencil, and it is applied on acme of colors already on a drawing surface. It is very effective when using soft cadre or thin colored pencils and sold in many craft or fine art supply stores.

• Question

  What is the easiest way to get (Caucasian) mankind tones with Prismacolor?

  

  Writingismypassion

  Community Answer

  The calorie-free pinks, rosy reds, and peach colors generally piece of work well for Caucasian flesh tones. For shading, utilise either a very dark pink or a soft brown.

• Question

  What colors are best for an old, red barn?

  

  Deep browns and umbers will make it look old. Blending cadmium red with a deep, reddish brown will create a nice faded look. Black is always very useful if y'all desire to become dorsum and add some tiny details that will add to the onetime and faded look.

• Question

  Where can I get a colorless blender?

  

  They are available online on Amazon or eBay. You can besides check out your local art stores or online art stores and store around for the lowest cost possible. When ordering online, be aware that your product may non come up for weeks, or that you may have to pay extra for shipping prices or revenue enhancement.

• Question

  How practise I clean my colorless blender?

  

  Endeavor rubbing the tip on a glutinous note or slice of chip paper, equally this will rub off any color it may have nerveless.

• Question

  Practice these techniques work with other colored pencils?

  

  Yes. Yous don't need to own whatever type of Prismacolor pencils to use the methods in this article.

See more than answers

Ask a Question

200 characters left

Include your email accost to become a message when this question is answered.

Submit

Advertisement

• Basic art blending techniques, similar cross-hatching, hatching, scumbling, and a dorsum and forth stroke can be used to expert upshot when blending Prismacolors.

• Sometimes, lightly colouring the colours with the colours touching, and slowly colouring in the dominant color will piece of work well too, and yous could add more colours at the early stages.

Advert

Things You'll Demand

• Prismacolor Pencils
• Pencil blender
• Bristle brush (with moderately stiff bristles)
• Soft rag/blending cloth

• Container (for solvent, glass preferred)
• Solvent (like mineral spirits)
• Synthetic pain brush
• Paper towel

• Adhesive tape (optional)
• Electric eraser (optional; recommended)
• Pencil case (optional)
• Pencil extender (optional; recommended)
• Soft cloth/rag (optional)

Video

Nearly This Article

Article Summary 10

To blend with Prismacolor pencils, endeavour layering darker colors over lighter colors with gentle pressure to add dimension. You lot can too lightly use white pencil over darker colors to blend and lighten hues. Another piece of cake blending technique is to pass a blender pencil, which you can go at art supply stores, back and forth over the area until the desired level of blending is reached. For tips on using solvents for blending, read on!

Did this summary assistance you?

Thanks to all authors for creating a page that has been read 180,171 times.

Did this article help you?

Source: https://www.wikihow.com/Blend-With-Prismacolor-Pencils

Posted by: whitesidewheark.blogspot.com

Share this post